In most cases, the framework is built for the lattice to be attached to. Since the lattice panels themselves have very little structural integrity, they either need to be attached to framework installed where the lattice is to be installed or the lattice panels need to have frames attached to the panels, giving them some structural strength. There are a number of ways that lattice panels can be installed, depending on the effort and expense that one wants to put into them. Once all the cross pieces are attached, the long pieces can be attached in the same way, once again stapling at every end joint and at the center crossbar. Then lay the cross pieces on those, stapling them together at each marked intersection (edges and that center crosspiece). Lay out the connection points on all the perimeter pieces and one piece that goes across the center. But the lath strips can easily be painted by lining them up on a table and painting or staining them with a paint roller.Ī large table or workbench will be needed for assembly. Painting lattice panels can be time consuming, unless it is done with an airless paint sprayer. It can be helpful to paint, stain or apply any other finish to the lath, before it is attached together to make the panels. This can give somewhat of a “plaid” design to the panel. For example, the standard spacing between strips can be the same as the width of the strips, and then every third strip can have double the spacing. Some very nice designs can be made by using staggering widths, forming a pattern. Please note that the strips do not necessarily have to be spaced evenly apart. If a band saw is available, less material will be wasted in cutting the strips. That allows the cutting of the strips either on the table saw or the band saw, with each cut being one strip. A very typical size for the lath strips is ¼” thick by 1 ½” or 2” wide, depending on the stock being used.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |